What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 01.07.2025 11:20
A circuit breaker is similar, but is resettable.
a photo is worth a thousand words.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
Ancient Blueprint For Human Bodies Discovered in Sea Anemones - ScienceAlert
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
Scientists Caught Sperm Defying One of Newton's Laws of Physics - ScienceAlert
(Dc diagram shown, AC is similar).
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
Where can one find good data science course in India?
This is where the MOV conducts again, and dissipated the energy.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
‘Echo Valley’ Is the Trashiest A-List Lifetime Movie You’ve Ever Seen - rollingstone.com
Now when you have a certain ac resistance, then a current flows in a loop.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
In schematic diagrams this is the symbol for a fuse:
eight
The MOV will conduct when the voltage exceeds 50% of line voltage.
What's the biggest myth about illegal immigrants?
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
This device then solves the entire problem.
Climate change leads to spread of infection-causing fungi, scientists say - ABC News
The bolt then partially travels down the line to your home.
What is lightning?
nine
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
There are three different concepts here that are getting confused.
so, what happens?
Derek Carr explains his decision to give up $30 million and retire - NBC Sports
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
There are two important concepts here.
But… the neutral is now “floating” because of the 1 ohm resistance.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
First Sentence:
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
For this case there are devices called Metal oxide varistors (MOV).
He then describes the function of a fuse.
But it can get overloaded, and no longer works.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
Because the load is inductive, the current lags the voltage.(by a bit).
An AC voltage/ current source, and an ac inductive load.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
One
but I think this circuit , shows a few more pieces.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
but this device (an Inductor) … impedes the rapid changes in the current.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
So, the voltage could go up to 500 volts, and the fuse will not open up.
At one ohm, the resistor has a maximum of 1 watt power.
I post the exact comment here.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
The third is lightning and “how it gets conducted into a home.”
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
[old diagram got deleted by accident]
What does a fuse do?
The other is “what does a “fuse” do?”
Upvotes:
This is where this question deviates from being a 'generic' question, and becomes more specific.
what exactly is a ‘surge’ protector?
2024–10–16 [ OO OLAOYE OYEBODE ]
These devices are installed between the “hot” and “neutral” and protective ground.
2024–10–10[John johnson John Johnson ]
2024–10–14 [Omar Gharbi Omar Gharbi ]
A fuse is a non-resetable over current circuit protector.
He then asserts :
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
This one hit behind the barn.
This is 'the assistant's answer'
It also is a device that limits the change in current flow.
It seems Mohan does not understand the difference between a comment and an Answer.
Barnstars:
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
He then describes Rainy Season and Lightning.
the problem then depends on "how fast does the fuse operate?".
These are simplified answers to the original question, and does not change anything I wrote above.
Edit 2024–10.
Here is a simplified AC power diagram.
One is “what exactly is in a ‘surge protector’ ? ”
[image of Common-mode choke]
At least they know the answer if they wanted it.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Can the fuse protect the electronic devices from lightning instead of a surge protector.